Analysis and solutions of how to solve the oil leakage phenomenon of pressure calibrator

Abstract: The analysis and solution information on how to solve the oil leakage phenomenon of the pressure calibrator is provided by the excellent flowmeter and flowmeter manufacturers and quotation manufacturers. In the use of the pressure calibrator, one of the primary requirements for its function is that the sealing performance is good, and each transmission channel must not have oil leakage. If there is oil leakage, it cannot be used and must be repaired. Common oil leaks in pressure calibrators and usually repaired. More flowmeter manufacturers choose models and price quotations. You are welcome to inquire. The following is the analysis and solution article details of how to solve the oil leakage phenomenon of the pressure calibrator. In the use of the pressure calibrator, one of the primary requirements for its function is that the sealing performance is good, and each transmission channel must not have oil leakage. If there is oil leakage, it cannot be used and must be repaired. The common oil leakage parts of the pressure calibrator and the usual repair methods are introduced for reference: 1. The connecting parts at the joint of the pressure calibrator are not well fastened, so oil seeps. The upper and lower nuts at the joint should be twisted in opposite directions to each other. Just do it. 2. The pressure gauge is not tightened to connect with the gasket in the joint, so the pressure gauge should be tightened again if the oil seeps, or the gasket should be thickened so that it can connect with the top plane of the pressure gauge joint. When the thread cooperation of the external joint is not good and oil leakage occurs, some of them are the deformation and damage of the tooth pattern of the external joint of the pressure gauge. You can use a suitable thread to twist it, otherwise you can wrap a few strands of fine yarn on the external joint of the pressure gauge. Or wrap it with PTFE raw material tape, and then tighten it. 3. The sealing gasket between the connecting parts of the pressure calibrator is aging and damaged, so oil leaks, some bxs should be disassembled and replaced with a new sealing gasket. 4. The closing valve is not tightened, or the thimble rod has burrs, so oil seeps. If the above conditions exist, if further closing of the valve is ineffective, the finish of the thimble rod should be repaired. A simple repair method, after applying the grinding sand with fine cotton yarn, wrapping it in the thimble rod*, grinding and polishing with continuous changes, can usually be corrected. 5. Oil leakage at the screw. Such conditions are mostly due to the wear of the rubber sealing cup at the top of the screw rod, and a new oil-resistant rubber cup should be replaced. The above is the whole content of this article. You are welcome to inquire about the flowmeter selection and quotation of our factory. 'How to solve the analysis and solution of the oil leakage phenomenon of the pressure calibrator'

Building a brand as Sincerity from the very start is simple so long as you keep 'the three C's' in mind: clarity, consistency and constancy.

Beijing Sincerity Automatic Equipment Co., Ltd is one of China's leading providers of state-of-the-art . For decades, we've served numerous residential, commercial, and industrial clients. To contact us for a free quote for your home or business please visit Sincerity Flow Meter.

have three basic components.

Deeper connections between Sincerity and mass flow meterare made when you go beyond the white lights of a corporate space.