Vortex flowmeter meter attention points

Abstract: The important points of attention for vortex flowmeter meters are provided by excellent flowmeter and flowmeter manufacturers and quotation manufacturers. 1. Reasonably choose the installation site and environment. Avoid the influence of high temperature heat sources and radiation sources, avoid strong vibration places and strong corrosive environments, etc., and consider the convenience of installation and maintenance. 2. There must be enough straight pipe sections upstream and downstream. If the sensor is on the mounting point. For more flowmeter manufacturers to select models and price quotations, you are welcome to inquire. 1. Reasonably choose the installation site and environment. Avoid the influence of high temperature heat sources and radiation sources, avoid strong vibration places and strong corrosive environments, etc., and consider the convenience of installation and maintenance. 2. There must be enough straight pipe sections upstream and downstream. If there are two 90s in the same plane upstream of the sensor mounting point. Elbow, then: upstream straight pipe section≥25D, downstream straight pipe section≥5D. If there are two 90s on different planes upstream of the sensor mounting point. Elbow, then: upstream straight pipe section≥40D, downstream straight pipe section≥5D. 3. The piping upstream and downstream of the installation point should be concentric with the sensor, and the coaxial deviation should not be less than 0.5DN. 4. Vibration reduction measures shall be taken for the pipeline. Try to avoid installing the sensor on the pipeline with strong vibration, especially the lateral vibration. 5. Installation on horizontal pipes is the most common installation method for flow sensors. When measuring gas flow, if the measured gas contains a small amount of liquid, the sensor should be installed at a higher part of the pipeline. When measuring liquid flow, if the measured liquid contains a small amount of gas, the sensor should be installed at the lower part of the pipeline. 6. Installation of sensors in vertical pipes. When measuring gas flow, the sensor can be installed on vertical pipes with unlimited flow direction. If the measured gas contains a small amount of liquid, the gas flow should be from bottom to top. When measuring liquid flow, the flow direction should be from bottom to top: this will not add extra liquid weight to the probe. 7. The sensor is installed on the side of the horizontal pipe. 8. The sensor is installed upside down in a horizontal pipe. This installation method is generally not recommended. This installation method is not suitable for measuring general gas and superheated steam. It can be used to measure saturated steam, and it is suitable for measuring high temperature liquid or when the pipeline needs to be cleaned frequently. 9. Installation of sensors on insulated pipes. When measuring high temperature steam, the insulation layer should not exceed a maximum of one-third of the height of the bracket. 10. Selection of pressure and temperature measurement points. The above is the whole content of this article. You are welcome to inquire about the flowmeter selection and quotation of our factory. 'Notes on Vortex Flow Meters'

Beijing Sincerity Automatic Equipment Co., Ltd is committed to fulfill the demands of our customers with using mass flow meter.

To learn more about mass flow meter， give us a call at Beijing Sincerity Automatic Equipment Co., Ltd or visit us online by going to Sincerity Flow Meter.

With the help of a endress hauser ultrasonic flow meter mass flow meter, coriolis density meter becomes a reasonably easy job that you can take care of simply and swiftly.

To do that, Beijing Sincerity Automatic Equipment Co., Ltd will need to make sure our business is listed accurately on as many directories as possible, including technology and quality.