Vortex flow meter scale pay attention to the point

Abstract: the scale vortex flowmeter note points information produced by excellent flow meter, flow meter manufacturer to offer you the quotation. 1, reasonable choose to install location and environment. To avoid the influence of high temperature heat source and the radiation source, to avoid strong vibration and strong corrosive environment and so on, at the same time to consider easy installation and maintenance. 2, upstream and downstream straight pipe must have enough. If the sensor is installed on. More flow meter manufacturers choose model price quote you are welcome to inquire, here is a vortex flow meter scale attention points for details. 1, reasonable choose to install location and environment. To avoid the influence of high temperature heat source and the radiation source, to avoid strong vibration and strong corrosive environment and so on, at the same time to consider easy installation and maintenance. 2, upstream and downstream straight pipe must have enough. If the sensor installed upstream of point on the same plane has two 90. Elbow, are: straight pipe upstream & ge; 25 d, the downstream straight pipe & ge; 5 d。 If the sensor installed upstream of point in different plane has two 90. Elbow, are: straight pipe upstream & ge; 40 d, downstream straight pipe & ge; 5 d。 3, installation point of upstream and downstream piping should be concentric with sensor, coaxial deviation should be no less than 0. 5DN。 4, pipeline vibration reduction measures. Sensor to avoid installed in the strong vibration, transverse vibration in particular. Installed in horizontal pipe runs is flow sensor zui installation method in common use. Measuring gas flow rate, if contain a small amount of fluid in the gas being measured, the sensor should be installed in the pipeline is relatively high. Measurement of liquid flow, if the liquid contains a small amount of gas being measured, the lower part of the sensor should be installed in the pipeline. The installation of sensors in a vertical pipe. Measuring gas flow rate, the sensor can be installed in vertical pipe runs, flow to the unlimited. If the measured gas containing a small amount of liquid, gas flow should be from the bottom up. Measuring the liquid flow rate, liquid flow shall be from the bottom up: it won't attach additional liquid weight on the probe. 7, sensors in a horizontal pipe to the side. Sensors in a horizontal pipe of inversion. Generally do not recommend using this installation method. This installation method is not applicable to measure the general gas, superheated steam. Can be used for measurement of saturated steam, high temperature suitable for measuring the liquid or frequent cleaning pipelines. The installation of sensors on have insulation pipe. When measuring high temperature steam, thermal insulation layer zui much can't more than a third of the bracket height. The choice of pressure and temperature measuring points. Above is all there is in this article, you are welcome to inquire me manufacturer flowmeter selection, quotation, etc.

However, with the increased prevalence of mass flow meter, it has become far more affordable.

Beijing Sincerity Automatic Equipment Co., Ltd humbly request you to try this item in your centers and we assure you that you would be in a great pleasure with the results.

The development of tuning fork liquid density meter mass flow meter products has massive potential for expansion.

Unlike the insertion ultrasonic flow meter, the is more flexibly used in accasions where low flow turbine flow meter .